3.3.3 Ethernet: Power Supply Using PoE Products (Power over Ethernet)
• Connect the 10BaseT/NET connector of the camera to the Ethernet con-
nector of the switch/router. The network components need to support the
PoE standard IEEE 802.3af.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
90/124
D12 Camera Manual Part 1
PoE IEEE 802.3af!
Note
If you are using IEEE 802.3af Power over Ethernet network compo-
nents for supplying power to MOBOTIX cameras, make sure that these
components do not have a fan. Since the power consumption of
MOBOTIX cameras is very low compared to other products, this in-
creases the reliability of the entire system and expands the life cycle of
these components.
PoE components without
fans increase overall reli-
ability of the entire sys-
tem
To Next Page
