17
SUBSTANCES FOR MILLING
AND ADJUSTING THE SETTINGS
You can use your Mockmill to
mill all foods listed on pages
14 - 16.
Milling substances other than
those listed or on our website
may damage your mill and void
the warranty.
Do you have an idea or would
you like to try something that
you can not find on the list?
Then please send us a mail to
info@mockmill.com. We would like
to support you and your milling
ideas.
Adjusting the setting
Your Mockmill has a very
wide range of settings, and
is designed for very precise
adjustment. The setting is
pre-adjusted so that you can
hear a quiet sound of the stones
touching at lever position 1
when idling without grain.
The same noise can be heard
after the transport locking
system has been removed from
the Mockmill 200. This is the
finest setting, with lever position
10 you get coarser result.
If you hear no milling noise at
the lever position 1 or a very
strong milling noise already
from level 2, please adjust the
Mockmill as follows:
Loosen the adjusting lever two
turns, push the lever to setting
10 and tighten the lever again.
Now move the lever in direction
to setting 1 with the appliance
running.
As soon as the stone contact is
noticeable by a slight ticking,
loosen the lever again, move it
to setting 1 and tighten it firmly.
If no stone contact is heared,
please repeat the process.
If you require a coarser result
than achieved on the first scale,
DE
EN
To Next Page
Loading...
Need help?
General
