18
you can adjust the Mockmill to
a coarser range as follows: With
the mill switched on, move the
lever as far as it will go towards
10. Now loosen the adjustment
lever. The lever now moves
freely back and forth. Move the
lever all the way back to postion
1 and tighten it back up (by
turning it clockwise). When you
now set the lever to 10 you will
get significantly coarser meal.
You can repeat this procedure a
second time if the milling result
is still not coarse enough for
your purposes.
To adjust the setting back
again to the fine range, proceed
as follows: Move the lever –
slowly – all the way to position
1. Now loosen it and move it over
to position 10. In this position,
tighten the adjusting lever
again. Repeat this procedure as
often as you did before to get to
the “coarse” setting range.
In position 1 you should hear
the quiet ticking noise made by
the milling stones when milling
chamber is empty. The Mockmill
is now set for a fine milling
result again. Once you have tried
out the procedure, it is easy to
use.
A video on this topic can be
found on our website under
Service / Help on mockmill.com
To Next Page
Loading...
Need help?
General
