Horizontal Filter Dust Collector Owner’s Manual
Copyright© 2018 Mod-U-Blast®, All Rights Reserved
Dust Collector Maintenance
10
Dust Disposal
Maintenance Schedule For Blastroom Pneumatic System
Daily Maintenance
Six Month Maintenance
1. Empty the dust container (s) as required to minimize the amount of dust in the hopper.
2. Whatever type of dust container is used under the hopper to collect the dust, care should be given to make sure it does not over fill -
empty the container when it is about 2/3 full or less.
3. Reinstall the dust container.
NOTE: If the 6” butterfly valve is left open during operation of the dust collector it must be sealed to the waste container.
NOTE: The auto pulse control panel uses a Zelio timer internally. Should the pulse time between filter banks need to be adjusted for any
reason please contact the Mod-U-Blast service departments for directions.
When servicing the dust collector disconnect and lock out the electrical supply and disconnect
the air supply from the compressor.
• Report and / or fix any operational problems
• Correct any safety issues
• Pulse dust filters (after seasoning)
• Empty dust collector hopper
• Check dust collector filters - if the magnehelic gauge on the DC reads 5- 6 inches even after
pulsing then the filters need replacing (see filter removal and installation)
• Check for leaks in dust hoses
To Next Page
Loading...