Horizontal Filter Dust Collector Owner’s Manual
Copyright© 2018 Mod-U-Blast®, All Rights Reserved
Important Safety Items
Read all instructions before using this equipment. For efficient and safe production reference the OSHA requirements.
1.1 Dust Collector Manual
This manual contains important instructions for the safe operation of this dust collector and some of its related equipment.
Before attempting to operate this dust collector and its components all personnel intending on using this equipment must read all of the
complete manuals and familiarize themselves with the operation and parts.
1.2 Safety Considerations
• Dust collectors require high pressure air to pulse the filters
• Dust collected by a reverse pulse collector must not be allowed to become concentrated in areas where workers are exposed. This
requires proper maintenance of the dust collection & Hepa components.
• When selecting a location for the dust collector take into consideration wind, seismic zone and all load conditions.
• Electrical installation, service and maintenance must be performed by a qualified electrician.
1.3 Operator’s Responsibilities Before Starting
• Inspect fittings, valves and hoses for damage and wear. Repair any air leaks before operating.
• Clean the dust collector filters as needed and empty the dust collector hopper daily.
IMPORTANT NOTE: When using this dust collector the filters need to be seasoned before pulsing. Do not turn on the auto pulse until 4-5
hours of blasting and/or one cycle of reclaiming media has occurred.
1.4 Cautions
• The compressed air supply to the pressure system needs to be oil and moisture free.
• Working air pressure of the dust collector pulse system must not exceed 80 P.S.I.
1.5 Maintenance
• Disconnect the power and air supply from the dust collector before servicing.
• Keep all components in good repair. Use Mod-U-Blast parts only and do not substitute or modify.
For Service Call:
1-800-661-3842
8
To Next Page
Loading...