Mod-U-Blast M2000-4C

To Next Page

To Previous Page

Horizontal Filter Dust Collector Owner’s Manual

Filter Removal and Installation cont’d

Removing the lid exposes the lters

Grab the lter as shown and pull out to remove. Most of the dust

collectors will have 2 lters except the M2000 and the M3000 which are

singles.

NOTE: Dirty lters may be heavier than they appear. Safe measures

should be taken when removing

When replacing the lters note that the end with the foam rubber seal

ALWAYS goes in rst whether it’s a single or double lter conguration.

Filter Installation

Reverse the above procedures when installing new lters

Mod-U-Blast M2000-4C - Page 12