Updating the Firmware
To update the Firmware on MODE, you must first register your device. After registering it head to the Downloads section and download the most recent
firmware. It will be a file that ends in UPD. Depending on what storage devices you use, the firmware update is slightly different.
MicroSD:
Power off your console and copy this firmware file to the root of your
MicroSD card. Power the console back on and you will be greeted with a
message prompting you to update the firmware. This message also provides
some other information such as current firmware and FPGA details.
Press the A button on the game controller to flash the new firmware
or press B to cancel and not update
MODE uses a single binary firmware for both Sega Saturn and Dreamcast.
There is no need to flash it separately for each console. The firmware is designed
to function on both consoles and either one can update the firmware.
SATA or USB:
You can also update the firmware if the file is copied to the root
of the USB or SATA disk. MODE will not prompt at boot up to
update the firmware if a firmware file is on those storage formats.
Instead, go into the options menu and select Check Update to
initiate a firmware scan and then update.
To Next Page
Loading...