12
Enameled parts of the grid can be washed or inserted to the dishwasher.
Burner
Burner can be removed and cleaned using soap water. After cleaning the burner, dry it completely and reinstall it on the
correct position.
Lighter and Gas Safety Device
Clean the lighter and gas security sensor after cooking, especially if there are drips or spills from the pan throughout the
cooking process
Perform inspection on the following matters before contacting our Service Center upon finding any disturbance on your gas
stove:
Lighter is
malfunctioning
• Check the power cord outlet. Is the cord removed from the source of electricity?
• Make sure that the outlet has electricity current. If the power is out and the automatic
lighter cannot be used, use match.
• Make sure that the star button is pressed / operated properly.
• Is the voltage 220 volt? Electricity voltage below 210 volt will render the lighter
inoperable.
• Make sure all knobs on the stove are OFF.
• Are the gas hose and regulator installed properly?
• Perform gas leakage test on the gas hose, regulator and gas tube, especially on
theconnection part.
• If the room still smells of gas, immediately remove the regulator from gas
cylinder.
• Do not light fire in the above condition
Abnormal fire
(red / small /
unstable)
• Make sure that the burner’s position on the stove is correct (aligned properly).
• Check whether there is adequate amount of gas in the gas stove
• Check whether gas supply is clean (for natural gas usage)
• Check whether the knob (fire adjustment) is on the required position
• Is the stove located in a room with good air circulation?
• Make sure the stove/burner is not soaked with spilled food, which may clog the fire hole.
• Clean the stove/burner, including the fire holes on the stove/burner.
• Check whether the spuyer/nozzle is covered in dirt
• Always turn down the fire or put out the fire before lifting the pan from the burner.
• During the cooking process, oil or fat must be treated carefully since it may ignite fire upon reaching certain
temperature
• Do not close the stove cover when the burner is still hot and the kitchen utensils still installed on the grid.
• Upon smelling a distinct gas odor, remove the regulator from the gas cylinder immediately. Do not
light any fire and contact MODENA Service Center.
• Inspect the regulator and gas hose regularly. Make sure that the gas hose is far from any hot surface and not currently
bent. Also, make sure that the external surface of regulator and hose is not cracked or damaged, which may result
in gas leakage.
Part 6: Problem & Solution
To Next Page
Loading...