6
3.A
Installation
1. Open the stove carton box / packaging.
NOTES:
In order to avoid any damage by rodents, we highly recommend setting up anti- rodent traps around the gas stove
(Optional).
2. Connect the gas stove to the stove and regulator by following the route specified in Picture 2, and secure both
connections using hose clamp.
ATTENTION:
• Use standardized hose for gas stove equipped with leak safety equipments.
• Use proper hose and regulator to avoid gas leak which may result in explosion.
• Do not use high pressure gas regulator
• Gas hose must not touch / attached to hot oven wall.
After the gas hose is properly installed, perform gas leakage test on the oven connection as follows:
• Connect the regulator with gas cylinder
• Smear soap water (soap mixed with water) on the connection.
• Observe the connection. Bubbles formed on the surface indicate gas pressure is leaking out of the connection.
• To repair a leaked connection, follow these instructions:
• Disconnect the regulator from the gas cylinder
• Secure the hose clamp on the leaked connection
• Repeat the gas leakage test (points a to c).
Attention:
Gas leakage test should be performed by a certified technician or MODENA Service Center officer.
3. For gas stoves with gas cylinder compartment secured with cross iron, install the cross iron on the stove. Open the
gas compartment door on the stove and install the cross iron by inserting the cross iron ends to the support holes.
4. Remove all stainless steel cover on stoves made of stainless steel materials, especially its working table.
5. Connect the power cord to the electrical power socket.
Attention:
Inspect electrical voltage and make sure the voltage meets the requirements specified on the label.
6. Insert the gas cylinder to the gas cylinder compartment for stoves equipped with gas cylinder compartment.
Attention:
To Next Page
Loading...