English 21
SHIPMENT AND REPOSITIONING
Original packaging and foam may be kept for re-transportation.
- Always follow the original instructions for /transportation found
on the packaging.The unit must be in a pretty package
wrapped with thick, covered with insulation and reinforced with
rope.
- When going to move the unit, remove the parts that easily fall
(racks, accessories, place vegetables etc.) Or if it will be left in the
unit, secure the insulation or using adhesive tape.
Always transport your unit in the upright position.
BEFORE USE THE UNIT
Information About No-Frost Technology
Refrigerators with No-frost technology differ from other static refrigerators in
their operating principle.
In normal fridges, the humidity entering the fridge due to door openings and
the humidity inherent in the food causes freezing in the freezer section.
To defrost the frost and ice in the freezer compartment, periodically
required to turn off the fridge, place the food that needs to be kept frozen
in a separately cooled container before remove the ice gathered in the
freezer section.
The situation is completely different in no-frost fridges. Dry and cold air is
blown into the fridge and freezer compartments homogeneously and
evenly from several points via a blower fan. Cold air dispersed
homogeneously and evenly between the shelves cools all of your food
equally and uniformly, thus preventing humidity and freezing. This allows the
storage capacity becomes larger and ease to use.
Installation and operation of refrigerator
- Before connecting the unit to a power source, ensure that the voltage on the name plate corresponds
to the voltage of the electrical system at your home.
- Operating voltage for your unit is 220-240 V at 50Hz.
- Before starting to use your refrigerator, please contact the nearest authorized servicer if help is
needed with the installation, operation and usage of your unit.
- The main power cord of your refrigerator has a grounded plug. This plug should be used with a
grounded receptacle that has a 16 A fuse minimum. If you don’t have a
receptacle conforming with this,please have one installed by a
qualified electrician.
- We do not take responsibility for any damages that occur due to
ungrounded usage.
- Place your refrigerator in a place where it is not exposed to direct
sunlight.
- This unit should be at least 50 cm away from stoves, ovens and heater cores, and should be at
least 5 cm away from electrical ovens.
- This unit should never be used outdoors or left under the rain.
- Fit the plastic wall spacers to the condenser on the back of the
refrigerator in order to prevent it from touching the wall and affecting
performance.
- When your rerigerator is placed next to a deep freezer, there should be
at least 2 cm between the appliances to prevent humidity on the outer
surface.
To Next Page
Loading...