English 22
- Do not place anything on top of your unit
- Install your refrigerator in a suitable place where there is at least 15 cm of clearance space
available on the upper side.
- If you place your refrigerator next to your kitchen cabinets, leave a space of 2 cm between the
appliance and the cabinets.
- Install the distance adjustment plastic (the part with black vanes at the rear) by turning it 90°, that
is to prevent the condenser from touching the wall.
- The adjustable front legs should be set at an appropriate height to allow
your refrigerator to operate in a stable and proper way. You can adjust the
legs by turning them clockwise or counter-clockwise. This should be done
before placing food in the unit.
- Before using your refrigerator, wipe all parts with warm water mixed with a
teaspoonful of sodium bicarbonate and then rinse with clean water and
dry. After cleaning, replace all parts in their proper locations in the fridge.
Before Using Your Refrigerator
- When operated for first time or after transportation, keep your refrigerator
in the upright position for at least 3 hours before plugging it in to allow
efficient operation. Otherwise, you may damage the compressor.
- This unit may have a slight odor when it is operated for the first time. The
odor will fade away when your refrigerator starts to cool.
Temperature Settings
Cooler and Freezer Thermostat Knob
The thermostat ensures that the temperature settings
in the cooling and freezing compartments of your
refrigerator are controlled automatically. It may be set
to any value ranging from 1 to 6. As you turn the
thermostat setting knob from 1 to 6, the amount of
cooling increases.
Cooling compartment thermostat knob:
5 - 6 : For more cooling.
3 - 5 : For normal utilization.
1 - 3 : For less cooling.
Point of Attention
- It is not recommended that you operate your refrigerator in environments colder than 10°C in
terms of its efficiency.
- The thermostat setting should be done by taking into consideration how often the fresh food and
freezer doors are opened and closed, how much food is stored in the refrigerator, and the
environment in which the refrigerator is located.
- After ready to install , the refrigerator should be operated up to 24 hours according to the ambient
temperature without interruption. Do not open doors of your unit frequently and do not place
much food inside it in this period.
- If a power cut / off, unplug the power cord from the wall socket, plug the power cord back +/- 10-15
minutes after the power is on a steady flow. After that the unit will start to operate normally after 5
minutes. This corresponds to a delay function is applied to prevent damage to your refrigerator
compressor.
- Your refrigerator is designed to operate in the ambient temperature intervals stated in the
standards, according to the climate class stated in the information label. It is not recommended
To Next Page
Loading...