User Manual MODSTER DASHER V2
www.modster.at 29
10. Disposal
Dispose of the product at the end of its service life in accordance with the applicable legal regulations.
Batteries
You as an end user are obliged by law (battery ordinance) to return all used batteries and accumulators; Disposal over
household waste is prohibited!
This symbol indicates the prohibition of disposal via household waste.
Batteries are also marked with the designation for heavy metal: Cd = cadmium, Hg = mercury, Pb = lead.
You can dispose of used batteries / accumulators free of charge at the collection points of your municipality or anywhere
where batteries are sold.
They fulll the statutory obligations and make your contribution to environmental protection.
Error solution
RC system does not work Check whether the system is switched on. Check the charge status of the batteries / accumulators of
the transmitter and the receiver. Check the polarity of the batteries / rechargeable batteries. Check
the contacts and plug - in connections of the receiver batteries / accumulators
Transmitter switches o
immediately or after short time Check the charging state of the transmitter‘s batteries
After switching on a warning signal
of the ESC sounds, motor does not
run Input voltage faulty, check the vehicle‘s battery
After switching on, the red LED
lights constantly, motor does not run Throttle/Break signal faulty. Check the connection between receiver and ESC
RC System has only a small range Check the charging state of the batteries of transmitter and receiver, charge, if necessary or replace.
RC system works faulty Interference pulse
A plug is loose
Receiver is defect (eg after a crash)
One or more electrical / electronic components have come into contact with moisture
Check cummonication of transmitter/receiver
Servo / ESC does not react Check whether the RC system is on. Check the charging state of the batteries of transmitter and recei-
ver. Check the polarity of the servo plugs.
The servos are trembling Check the charging state of the batteries of transmitter and receiver. Check whether moisture has
come in contact with the receiver and, if necessary, carefully dry with a hot air fan.
Servo is humming Check the charging state of the batteries of receiver. Check the smooth operation of the articulated
linkages. Remove the servo and test for function.
Servos do not respond properly Batteries of transmitter or receiver are weak
Gear wheels in the servo gear do not work or are defective
Adjusting rings on the link levers are loose
Reverse switch on the transmitter was inadvertently switched to „REV“
Check the charge status of the driving battery and transmitter‘s batteries
The model does not respond
Motor does not start even though
the servo is responding Motor does not start even though the servo is responding; Motor is defective
Motor cable loose, motor becomes too hot
To Next Page
Loading...
Need help?
General
