EasyManua.ls Logo

MODSTER HOBBY ARROWS Bae Hawk - User Manual

MODSTER HOBBY ARROWS Bae Hawk
26 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
BETRIEBSANLEITUNG MANUAL
50mm Bae Hawk
50mm Bae Hawk Vector

Questions and Answers

  • N
    Natalie SmithAug 9, 2025
    Why is my MODSTER HOBBY ARROWS Bae Hawk aircraft flight time reduced?
    • C
      Connor ValentineAug 10, 2025
      Reduced flight time or an underpowered aircraft can occur if the flight battery charge is low, the propeller is installed backward, or the flight battery is damaged. Recharge the flight battery or replace it, following the battery instructions.
  • A
    Andrea JonesAug 15, 2025
    What to do if MODSTER HOBBY ARROWS Bae Hawk Toy motor loses power or pulses?
    • D
      Donna AllenAug 15, 2025
      If the motor loses power or pulses, it could be due to damage to the motor or battery, loss of power to the aircraft, or the ESC using a default soft Low Voltage Cutoff (LVC). Immediately land the aircraft and recharge the flight battery. Check the batteries, transmitter, receiver, ESC, motor, and wiring for any damage, and replace parts as needed.
  • A
    Aaron RogersAug 19, 2025
    Why is there excessive vibration or propeller noise in my MODSTER HOBBY ARROWS Bae Hawk?
    • J
      John RileyAug 19, 2025
      Excessive vibration or propeller noise can be caused by a damaged spinner, propeller, motor, or motor mount, loose propeller and spinner parts, or the propeller being installed backward. Replace any damaged parts, tighten all parts for the propeller adapter, propeller, and spinner, and ensure the propeller is installed correctly.
  • K
    kennedynicholasAug 25, 2025
    What to do if MODSTER HOBBY ARROWS Bae Hawk responds to controls but not throttle?
    • L
      Luke CarrilloAug 25, 2025
      If the aircraft responds to other controls but not the throttle, it could be that the ESC is not armed, or the throttle channel is reversed. Lower the throttle stick and throttle trim to the lowest settings. If that doesn't work, reverse the throttle channel on the transmitter.
  • R
    Richard OrozcoAug 29, 2025
    How to fix unresponsive control surfaces on MODSTER Toy?
    • J
      John BartlettAug 29, 2025
      Unresponsive or sluggish control surfaces can be caused by damage to the control surface, control horn, linkage, or servo, or by damaged wires or loose connections. Replace or repair any damaged parts and adjust the controls. Check all connections for loose wiring.
  • M
    Maureen BoyleSep 3, 2025
    Why are the MODSTER HOBBY ARROWS Bae Hawk controls reversed?
    • E
      Eric LarsenSep 3, 2025
      If the controls are reversed, it means the channels are reversed in the transmitter. Perform the control direction test and adjust the controls for both the aircraft and the transmitter.

MODSTER HOBBY ARROWS Bae Hawk Specifications

General IconGeneral
BrandMODSTER HOBBY
ModelARROWS Bae Hawk
CategoryToy
MaterialEPO Foam
Channels6
Propeller5-blade EDF
ESC40A
Servos5x 9g
Battery11.1V 1300mAh 3S LiPo
Recommended Battery3S 11.1V 2200mAh LiPo
Radio System2.4GHz

Related product manuals