Moeller PG-NZM User Manual

1/7
A
03/02 AWA1230-1715
Montageanweisung
Installation Instructions
Notice d’installation
Istruzioni per il montaggio
Instrucciones de montaje
Инструкция по монтажу
Lebensgefahr durch elektrischen Strom!
Nur Elektrofachkräfte und elektrotechnisch
unterwiesene Personen dürfen die im Folgen-
den beschriebenen Arbeiten ausführen.
Electric current! Danger to life!
Only skilled or instructed persons may carry out the
following operations.
Tension électrique dangereuse !
Seules les personnes qualifées et averties doivent
exécuter les travaux ci-après.
Tensione elettrica: Pericolo di morte!
Solo persone abilitate e qualificate possono eseguire
le operazioni di seguito riportate.
¡Corriente eléctrica! ¡Peligro de muerte!
El trabajo a continuación descrito debe ser realizado
por personas cualificadas y advertidas.
Электрический ток! Опасно для жизни!
Только специалисты или проинструктированные
лица могут выполнять следующие операции.
PG-NZM
2 x
ON
TEST
FAU LT
ESCESC
OK
PG-NZM
TEST
60V
+
115 V AC/ 1.2 A (T)
230 V AC/ 0.63 A (T)
50/60 Hz
200 VA
I
O
230
0
For Immediate Delivery call KMParts.com at (866) 595-9616

Moeller PG-NZM Specifications

General

Brand	Moeller
Model	PG-NZM
Category	Industrial Electrical
Language	English

Summary

General Safety Warnings

Electrical Hazard Warning

Warning about danger to life from electric current, requiring skilled personnel.

Device Overview and Components

Component Identification

Identification of device components through numbered labels and descriptions.

Mains Voltage Selection and Fuse Change

Instructions for selecting mains voltage and changing the fuse accordingly.

Test Cable Connections

Connect Test Cables to NZM2, 3, 4

Procedure for connecting test cables to the NZM2, 3, 4 trip block.

Connect Test Cables to NZM10

Procedure for connecting test cables to the NZM10 trip block.

Advanced Test Cable Connections

Connect Test Cables to NZM10 + TV-NZM10

Connecting test cables to NZM10 + TV-NZM10 trip block.

Connect Test Cables to NZM12 and Polarity

Connecting test cables to NZM12 and ensuring correct polarity.

Test Setup and Operation

Select NZM Type for Testing

Selecting the correct NZM model (NZM2, NZM3, NZM4, NZM10) for testing.

Initiating and Monitoring Test

Performing tests using the tester's controls and monitoring status.

Test Current Adjustment and Results

Setting Test Current (Coarse and Fine)

Adjusting the test current in coarse and fine steps for testing.

Test Phases and Tripping Time Display

Understanding test phases and interpreting displayed tripping times.

Display Information and Troubleshooting

Interpreting Display Messages

Explanation of display messages and their causes.

Thermal Memory and Cooling Time

Understanding thermal memory and waiting for cooling time after test trips.