MoJack WorkBench - Page 8

MoJack WorkBench
8
Operating Instructions for use with MoJack EZ
STEP 3
Raising the Mower
s2AISETHEMOWERBYROTATINGTHE#RANK(ANDLECLOCKWISE
Do not attempt to lift more than 200 lbs.
The MoJack must be used on a solid level surface.
The mower engine must be turned off.
If using the WorkBench Inserts, do not install past
safety sticker.
STEP 5
Lowering the Mower
s0ULLANDHOLDTHE#ARRIER,OCKING
Pin out and turn the Crank Handle
counterclockwise until Wheel Pads
are firmly on the ground. The Carrier
Locking Pin must be pulled out until
it clears the bottom Safety Hole.
Safety Holes
Safety Hole
Carrier
Locking
Pin
Pull Out
to Unlock
and Lower
Tower Locking Pin
STEP 4
Raising Lift Arm to Locking Position
s2AISETHE,IFT!RMUNTILTHE#ARRIER,OCKING0INDROPSINTOTHE
Safety Hole.
s4HE#ARRIER,OCKING0INAUTOMATICALLYDROPSINTOTHE3AFETY(OLESAS
the Carrier passes the Safety Holes on the Tower when raising.
s.OTE7HENLOWERINGTHE,IFT!RMTHE#ARRIER,OCKING0INMUSTBE
held out by the operator until it clears the bottom Safety Hole.
Safety Hole
Carrier
Locking
Pin
Pull Out
to
Unlock
and
Lower