Moki PAIRBUDS - Reset Inter-Pair Connection

8
Once the PairBuds have been turned ON, the “L” Pair-
Bud LED will flash red/blue while the LED on the “R”
PairBud will flash blue. You may then pair the PairBuds
with your Bluetooth device.
If the PairBuds fail to pair a reset is required.
1) Power o both PairBuds. Hold buttons for 3-5
seconds. LED blinks red once then o.
2) Press and hold the buttons on each PairBud for
about 8 seconds or until the LED indicators on both
rapidly blink red/blue (this will reset pairing on both).
Place both PairBuds back in ChargeDock and remove
again after 3 seconds.
3) PairBuds will re-establish a connection with each
other. The left PairBud will flash red/blue and the
right PairBud will flash blue only. After inter-pairing is
successful, connect to your Bluetooth device.
INTER-PAIRING
THE PAIRBUDS
(continued)
RESET
INTER-PAIR
CONNECTION