To Next PageTo Next Page
Need help?Do you have a question about the Monacor PA-2240 and is the answer not in the manual?
General| Power Output | 240 W |
|---|---|
| Power supply | 230 V AC, 50 Hz |
| Power Output RMS | 240 W |
| Frequency Response | 20-20, 000 Hz |
| Input Impedance | 10 kΩ |
| Frequency range | 20-20, 000 Hz |
| Input Sensitivity | 0.775V (line) |
| Signal-to-Noise Ratio | Over 75 dB |
Details the front panel controls and indicators: level controls, LEDs (CLIP, PWR, PROT, TEMP), and the power switch.
Covers rear panel connections: power, speaker outputs, monitor speaker, and input jacks (XLR, screw terminals).
Details requirements for rack mounting: space, placement, and secure fixing using rear straps.
Explains speaker connection types (PA, 100V monitor, 8-ohm), impedance, polarity, and safety precautions.
Describes input signal connection via XLR/screw terminals, routing, and sensitivity requirements.
Covers connecting the mains cable and setting up an emergency power supply for continuous operation.
