To Next Page
J
Jason MillerSep 10, 2025
How to fix printing shadows or smears on Monarch Printer?
- MmdavisSep 10, 2025
To resolve printing shadows or smears with your Monarch Printer, try cleaning the printhead, changing the supply, and checking the ribbon.
How to fix printing shadows or smears on Monarch Printer?
To resolve printing shadows or smears with your Monarch Printer, try cleaning the printhead, changing the supply, and checking the ribbon.
What to do if my Monarch 9855 is printing light?
If your Monarch printer is printing too lightly, try these steps: change the supply, adjust the print contrast, check the wide/narrow knobs, and check the ribbon.
What to do if my Monarch Printer is printing heavy?
If your Monarch printer is printing too heavily, try these steps: clean the printhead, change the supply, adjust the print contrast, check the wide/narrow knobs, and check the ribbon.
What to do if my Monarch 9855 is printing with voids?
If you notice voids in the printouts from your Monarch printer, try these steps: clean the printhead, change the supply type, and check the ribbon.
What to do if I get an error message during Monarch Printer startup?
If you receive an error message when starting your Monarch printer, turn it off, wait fifteen seconds, and then turn it back on. If the error message reappears, call Technical Support.
How to fix Monarch Printer when it does not read or program the RFID tag?
To fix the Monarch printer when it does not read or program the RFID tag, ensure that the protocol and attenuation settings are correctly configured for your inlay (HF RFID tag) type. Consult your HF Setup Guide & Supply Chart for detailed information.
What does it mean when my Monarch 9855 displays “744 Tag locked fail.”?
If the Monarch printer displays “744 Tag locked fail,” it means the RFID tag is already locked and unable to be programmed. This indicates a bad RFID tag.
What does it mean when my Monarch 9855 Printer displays “746 Lock tag fail.”?
If the Monarch printer displays “746 Lock tag fail,” it means the RFID tag has not been locked to prevent reprogramming. This indicates a bad RFID tag.
What to do if Monarch 9855 Printer displays “743 Program tag failed”?
If the Monarch printer displays a “743 Program tag failed” error, it means the RFID tag was detected but couldn't be programmed. Try increasing the number of write attempts. If the error persists, adjust the attenuation setting by one increment, either increasing or decreasing it. Be aware that setting the attenuation too low might affect the data programmed in adjacent labels.
What to do if my Monarch Printer errors when downloading a script?
If your Monarch printer encounters an error when downloading a script, check the available flash memory. You may need to format flash memory or clear NVRAM.
General| Resolution | 203 dpi |
|---|---|
| Print Method | Thermal Transfer |
| Max Print Width | 4.09 in (104 mm) |
| Media Sensor | Reflective and Transmissive |
| Interface | USB |
| Print Technology | Thermal Transfer / Direct Thermal |
| Print Speed | Up to 4 ips (102 mm/sec) |
| Print Width | 4.25 inches |
| Paper Handling | Roll-fed, fanfold |
