Fig. 8
14
REPLACEMENT OF BATTERIES
Take the meter out of the housing by bending up in the
lower end with something sharp.
The batteries, 2 x 1.5V size AA(R6), which are placed
in the holder on the backside of the meter, can then
easily be changed.
See fig.8.
After the batteries has been replaced all segments in
the display are visible and a buzzer will sound for two
seconds.
After 2 seconds the meter turns to main display again
and normal function.
Put the meter into the housing again.
Note: On the backside of the meter is a switch to
change meter function from km to mile or mile to
km.See fig. 9.
Batteries
km/mile
To Next Page
Loading...
