SPIKED FOOT
For Carpeted Floors
(Silver RX6 & RX8 only)
The Silver RX spiked foot encorporates a spike for use on carpeted floors and also, a soft
polymer pad for use on wooden or tiled floors.
Please ensure there are no hidden wires under the
carpet that could be damaged by the spikes.
The foot comes fully assembled for use on carpeted
floors. All that is required is fixing into the plinth. This is
achieved by screwing the feet fully into the 4-threaded
insert in the underside of the plinth. If your carpet has
a very thick pile, remove the soft polymer pad from the
foot to ensure the spike goes right through the carpet
into the floor. With great care turn your cabinet the right
way up. Place the cabinet in your desired location, and
check that it is level on all sides. If it is slightly off level,
unscrew the spike at the lowest point and check again.
Continue this process until the cabinet is fully level. Use
the locking nut on the foot to fix the foot in place and to
stop any unwanted vibrations.
For Wooden/Hard Floors
(Silver RX6 & RX8 only)
For use on solid floors or where spikes are inappropriate, it is possible
to use the foot without the spike insert. To use the foot in this manner
carefully grip the knurled portion of the spike and rotate anti clockwise
to unscrew the spike fully.
You may find it easier to first remove the polymer pad so as to gain
more purchase on the spike. The pad should be replaced before
carrying out the levelling operation described above.
Locking Nut
Main Threaded
Assembly
Spike
Polymer Pad
monitoraudio.co.uk 11
To Next Page
Loading...
Need help?
General
