TO SET PARAMETERS
1. With the oven in standby (OFF showing in display), press stop 2 and program 8
together and hold for about six seconds until a beep is heard.
“1” will show in the program display window.
2. This is the fan forward/reverse time.
The time the fan goes in each direction before changing.
Maximum of 180 seconds.
Press up 6 to increase or 7 to decrease the time required.
3. Press start 1 and “2” will show in program display window.
This allows the settings to be in degrees C or F
Press up 6 or 7 to change.
4. Press start 1 and “3” will show in program display window.
This is the “standby delay time setting.
00 = disabled. Setting can be up to 90 minutes (maximum) in 10 minute increments.
5. Press start 1 and “4” will show in program display window.
This shows the latest firmware revision.
6. Press stop 2 to exit setup and save the parameters.
To Next Page
Loading...
