Water Filter Cartridge
Built-In Refrigerators
Water filter
cartridge
Thewater filter cartridge islocated in the top
machine compartment of the refrigeraton
To Replace the Filter:
The filter cartridge is designed
to filter 300 gallons of water
{lasting approximately 12 months}.
Thereis a replacement indicator light
@
HeLD 3 SEC
for the water filter cartridge on the temperature
control panel.Thislight will turn yellow to tell
you that you need to replace the filter soon.
Thefilter cartridge should be replaced when
the replacement indicator light turns red
or if the flow of water to the dispenser
or icemaker decreases.
Installing the Filter Cartridge:
1. Removethe old cartridge bg slowly turning
it to the left. A small amount of water may
drip down. Do not pull down on the cartridge.
2. Fillthe new cartridge with water from the tap
to allow for better flow immediately after
installation.
3. Line up the arrow on the cartridge with
the center of the holden Do not push it up
into the holder.
4. Slowly turn it to the right until the cartridge
stops. It will rotate about 1/4 turn. DO NOT
OVERTIGHTEN.
To Reset the Filter Status Light:
Press and hold the RESETpad for 3 seconds.
Filter BypassPlug:
Youmust usethe filter bypass plug:
a) if you have a household
reverseosmosiswater system
and/or another form of home
water filtration system
b) if a replacement filter is not
available.
I t Filter
'_'Bypass
Plug
€,,
Thebypass plug and the mini-manual are located
in the top machine compartment.
Theicemaker and dispenser will not operate
without the filter or filter bypass plug installed.
Replacement filters:
Toorder additional filter cartridges in the United
States, visit our Website at monogram.corn, or
call GEParts and Accessories, 800.626.2002.
Customersin Canada should consult the yellow
pages for the nearest Mabe ServiceCenter.
Cartridge
Cartridge
Slowly turn it to the right
Do not overtighten
IMPORTANTNOTE:Remove the water filter to
immediately stop any water leak from the
Icemaker/Dispenser system. The water filter
cartridge holder (bracket) acts as a cut-off valve
when the filter is removed and will prevent
further leaking.
Call 1.800.844.1845 to schedule a service call
to repair the leak.
To Next Page
Loading...
