10
EN
You can use the fingerprint sensor to access the Windows Hello functions.
The Windows Hello functions include signing in with fingerprint authentication instead of
password, to the Windows user account for which you have enrolled your fingerprint .
For more information about the functions and setup of Windows Hello,
refer to the Windows Hello help.
Enrolling your fingerprint Follow these steps to set up Windows Hello and enroll your
fingerprint.
1. Select (start), (Settings), and Accounts.
2. Select Sign-in options and set your password. If you have already set your password,
proceed to step 3.
3. Follow the on-screen instructions for each fingerprint authentication to enroll your
fingerprint. If you have not set a PIN, set it at the end of the procedure.
Your Huma does not come with any recovery media.
Be sure to create your own recovery media with a USB flash drive before you first use the
computer following your purchase. For more information,
refer to the Safety Guide/ Recovery and Troubleshooting Guide.
Upon completion of the Windows setup, select (start), (Power},
and then Shut down or Sleep.
Creating your own recovery media
Turning off or placing your Huma into Sleep mode
Always be sure to use the AC adapter to connect your Huma to a power outlet
before doing a recovery.
Note
4. USING THE FINGERPRINT SENSOR
To Next Page
Loading...
