Preparation for Use
Unpacking and Set Up
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you
operate the controls. These 'feet' are made from non-migrating rubber material specially formulated
to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave
marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware stores and home
improvement center everywhere, and apply these pads to the bottom of the rubber 'feet' before you
place the unit.
Important Notes:
3
• Safety and operating instruction manual should be retained for future reference.
• The apparatus should not be exposed to dripping, splashing or placed in a humid atmosphere such as a
bathroom.
• Do not install the product in the following areas:
• Places exposed to direct sunlight or close to radiators.
•
On top of other stereo equipment that radiate too much heat -Blocking ventilation or in a dusty area.
• Areas where there is constant vibration.
• Humid or moist places.
• Do not place near candles or other flames.
• Operate the product only as instructed in this manual.
• Before turning on the power for the first time, make sure the soundbar is plugged to power outlet.
• For safety reasons, do not remove any covers or attempt to gain access to the inside of the product. Refer
any servicing to qualified personnel.
• Do not attempt to remove any screws, or open the casing of the unit; there are no user serviceable parts
inside. Refer all servicing to qualified service personnel.
• Remove the soundbar from the carton and remove all packing material from the soundbar. Save the
packing material, if possible, in case the soundbar ever needs to be serviced or transported.
• The original carton and packing material is the only safe way to pack your soundbar to protect it from
damage in transit.
• Remove any descriptive labels or stickers on the front or top of the cabinet. Do not remove any labels
or stickers from the back or bottom of the cabinet.
• Place your soundbar on a level surface such as a table, desk or shelf, convenient to an AC outlet, out
of direct sunlight, and away from sources of excess heat, dirt, dust, moisture, humidity, or
To Next Page
Loading...
