Monster Speaker - My Beatbox suddenly stopped working and the red LED is flashing.; My iPod;iPhone does not respond to the remote control.; The system wont respond to any controls.

Problem What to do
My iPod/
iPhone
does not
respond
to the
remote
control.
• Make sure there’s a clear path between the remote
and the system with no obstructions.
• Wipe the small lens on the front end of the remote
using a clean, dry cloth.
• Bright room lights or sunlight can cause interference.
Try using the remote from another location.
• Remove your iPod/iPhone from the dock.
Wait 5 seconds. Then reseat your iPod/iPhone.
• Make certain the remote battery is installed correctly.
If it is old, replace it.
The
system
won’t
respond
to any
controls.
• Reset the system. First, unplug the power cable for 60
seconds. Next, plug it back in.
• Contact your dealer or Monster
®
Customer Service.
Problem What to do
My
Beatbox
™
suddenly
stopped
working
and the
red LED is
flashing.
• Carefully check if the back plate of the amplier is
hot. If the Beatbox has been running at it’s highest
power output for an extended period, the amplifier may
have overheated and the protection circuitry has
shut down the Beatbox temporarily. Your Beatbox
provide maximum protection from, amplifier
overdrive, and overheating. Switch off the Beatbox
and wait 30 minutes to let the back plate cool down.
Switch the power back on.
• Raise the volume to check they are operating normally.
• If the Beatbox is still not responding, contact
the dealer you purchased them from, or Monster.
My iPod
®
/
iPhone
®
does not
charge
up.
• Make sure you have the power cord properly
connected on the back of the unit.
• Make sure you have the power cord plugged
into a working AC outlet.
• Remove your iPod/iPhone from the dock.
Wait 5 seconds. Then reseat your iPod/iPhone.
17
18