What to do if my Monterey Boats M22's inboard engine suddenly shuts down and won’t restart?
If the inboard engine suddenly shuts down and won’t restart, check the monitor panel for a green light. Also, inspect the engine compartment.
What to do if the bilge pump will not run when the manual switch is activated on my Monterey Boats Boat?
If the bilge pump will not run when the manual switch is activated, replace or reset the circuit breaker. Ensure the battery switch and bilge pump breaker are turned on. Clean the pump impeller housing. Replace the connectors and secure them above the bilge waterline. Replace the switch or the pump if necessary.
What to do if the automatic switch on the bilge pump does not activate the pump on my Monterey Boats Boat?
If the automatic switch on the bilge pump does not activate the pump, reset the circuit breaker. Charge or replace the battery. Clean the pump impeller housing. Replace the connectors and secure them above the bilge waterline. If none of these steps work, replace the pump.
What to do if my Monterey Boats Boat's engine runs too cold?
If the engine runs too cold, replace the thermostat. If the issue persists, replace the temperature gauge or sender.
Why is my Monterey Boats Boat's outdrive power steering over steering?
If the outdrive power steering over steers or does not respond properly, free the cable and ensure no cables or wire harnesses are attached to it. Replace the cable if necessary. You may also need to service the sensor valve, and grease the outdrive.
How to fix reduction in water flow from the bilge pump on my Monterey Boats M22?
If there's a reduction in water flow from the bilge pump, clean the screen at the base of the pump. Also, check the discharge hose and clean or repair it as needed. Reroute the hose so it runs uphill from the pump to the thru-hull fitting, and check the battery and wire connections.
What to do if my Monterey Boats M22 Boat engine suddenly will not operate at or above cruise RPM?
If the engine suddenly will not operate at or above cruise RPM, find and correct the problem. Replace any faulty components. Also, check the throttle adjustment or cable.
Why is my Monterey Boats Boat's outdrive power steering slow and jerky?
If your outdrive power steering is slow and jerky, try tightening or replacing the belt. Fill the pump and check for leaks. Also, grease the outdrive.
What to do if Monterey Boats Boat engine loses RPM but hull is clean?
If your engine is losing RPM despite the boat not being overloaded and the hull being clean, inspect and replace the fuel filter. Also, repair the engine control system.
Why is my Monterey Boats M22 sluggish and losing speed & RPM?
Your boat might be sluggish due to several reasons. Start by cleaning the hull and running gear. Ensure the propeller is clean. Reduce the load on the boat. Also, pump out the bilge, identify, and correct the underlying issue. If these steps don't resolve the problem, have a qualified marine technician check the throttle control system.
Discusses Proposition 65 and emission standards for California.
Defines DANGER, WARNING, and CAUTION statements for safety.
Lists essential safety equipment required by USCG.
Prevents starting engine in gear; testing.
Operation and safety of the engine kill switch.
Lists PFDs, VDS, and sound signaling devices.
Extinguisher requirements and maintenance.
Safety procedures for fire emergencies.
Description and operation of the automatic system.
Importance of first aid and kit contents.
Examples and importance of warning labels.
Basic navigation rules for vessel interaction.
Essential checks before starting the engine.
Post-start engine checks and procedures.
Techniques for docking and securing the boat.
Handling failures in critical systems.
Actions to take after a collision.
Procedures for grounding and towing.
Emergency actions for flooding or capsizing.
Procedures for recovering a person overboard.
Understanding load and capacity limits.
Safe practices for towing the boat.
Description of inboard engine and outdrive systems.
How propeller selection impacts performance.
Types, selection, and maintenance of propellers.
Description of gauges and displays at the helm.
Audible alarms for critical engine systems.
Description of throttle and shift controls.
How cable controls operate.
Optional electronic control system operation.
Operation and safety of the engine kill switch.
Prevents starting engine in gear; testing.
Adjusting outdrive position for optimal running.
Description of power-assisted cable steering.
Maintenance for engine and steering controls.
Details of sealed US fuel systems.
Procedures for fueling boats.
Periodic inspection and maintenance of the fuel system.
Operation and connection of the shore power charger.
Periodic inspection and cleaning of electrical components.
Operation of the bilge pump system.
System for removing heat and fuel vapors.
Hull cleaning, painting, and anode maintenance.
Preparing the boat for storage.
Methods for supporting the boat during storage.
Steps for preparing the boat itself for storage.
Specific steps for winterizing the boat.
Preparing the boat after storage.
Common issues with steering and throttle controls.
Troubleshooting engine performance and starting issues.
Common gauge display and function issues.
Technical specifications for the M20 model.
Technical specifications for the M22 model.
General| Beam | 8' 6" |
|---|---|
| Fuel Capacity | 45 gal / 170 L |
| Deadrise | 20 degrees |
| Max Horsepower | 300 HP |
| Seating Capacity | 11 |
| Passenger Capacity | 11 persons |
To Next Page