The sole use of 3-in-1 tablets is not recommended as failure to add
salt to the salt container will leave your dishwasher exposed to
limescale damage which is not covered by the manufacturers
guarantee. Protect your appliance by adding salt as follows:
Remove the lower basket and then unscrew the salt container cap (1).
Add water and approximately 1kg of specialist dishwasher salt to the
container (Image 3, Jug not included) until almost overflowing. N.B. It
is normal for a small amount of
water to come out of the container
whilst filling it with salt.
Note: Fill the salt compartment with water at first use only.
Now replace the screw cap correctly and ensure that it is tight. If not,
salt may leak into the dishwasher chamber which can be detrimental
to the stainless steel interior. This is not covered by the manufacturers
guarantee.
After adding salt you should run a programme immediately to activate
the water
softener and flush away any salt spilled into the machine.
If salt is low the indicator light will show on the control panel.
To Next Page
