MOODY Eclipse 33 - Hull, Deck Gear & Below Decks; Hull Construction Details

Hull, deck gear & below decks
Hull
Glass Reinforced Plastic (GRP) is used throughout the construction of the hull and
decks. Hull stiffening is achieved using balsa or foam stiffeners moulded to the
inside of the hull and by the fitting of bulkheads. Each bulkhead is bonded in
position using GRP and then further secured with bolts through the GRP bonding.
An inner GRP floor also adds to the strength and stability of the hull. Extra
strengthening is also applied to the keel attachment area in order to withstand the
loads imposed on the keel. Deck areas are surfaced with an integrally moulded non
slip finish.
Keels
The following keel options are available:-
Yacht
Moody 31
Moody 336
Moody 35
Moody 376
Moody 425
Eclipse 33
Eclipse 38
Eclipse 43
Keel Options
Fin or Bilge
Fin or Bilge
Fin or Bilge
Fin or Scheel
Fin or Scheel
Fin or Bilge
Shoal
Shoal
Issue 3
Page 1.1