Mooer GEM Box - Operation Guide; Patch Selection Procedure; Powering On the Device; Master Volume Adjustment

08
Operation
Patch Selecting
Power On
Plug the cable of AC Adapter
(9V, 300mA, center minus) into
the [DC 9V] Jack, when using
batteries, plug the guitar cable
into this jack will turn the device
on.
Selecting Patches
Set the Module Selector to [PLAY],
the LED display will show the
information of bank and patch
number, step on [PATCH +/-]
footswitch to change patches (Hold
one footswitch to switch patches
quickly).
Pressing [PATCH +] footswitch time and again (or holding [PATCH +]
footswitch) cycles through patches in the order ~ ... ~ , ~ ...
~ , . Pressing or holding [PATCH –] footswitch will switch
patches in the opposite order.
Adjusting the master volume
Set the Module Selector to [PLAY],
rotate [VALUE] knob to adjust the
master volume of GEM Box (when
setting up the master volume, LED
display will show the current level).
The range of master volume is ~ ,
70 is the default value.
01
03
02
BANK
Bank
name
Patch
name
PATCH
# EDIT
BANK PATCH
# EDIT
INPUT
OUTPUT
DC9V
(PHONES)