Need help?Do you have a question about the Mooer GE300 and is the answer not in the manual?
Instructions for connecting and using the AC adapter.
Safety advice for connecting and disconnecting equipment.
Recommended methods for cleaning the unit.
Notes on potential radio and TV interference.
Conditions to avoid for unit placement.
Compliance statement with FCC rules.
Details of the display for live performance context.
How to customize and view the signal chain of effects.
Default mode balancing preset selection and CTRL footswitches.
Mode offering more direct access to programmable CTRL footswitches.
Using the GE300 for direct output and backline amplification.
Integrating external stereo effects pedals and units.
Connecting the GE300 with a guitar amplifier using the 4CM.
How to rearrange the order of effect blocks in the signal chain.
Settings for waveform, pitch, attack, and level of synth voices.
Settings for pattern and speed of the arpeggiator.
Controls for overall synth output and routing.
Diagram illustrating the signal flow within the synth engine.
Explanation of sensitivity, threshold, ratio, and other compressor settings.
Settings for position, peak, low/high frequency, Q, and mix.
Settings for rate, range, peak, Q, and curve of auto wah.
Parameters for touch wah, including attack, sens, peak, Q, and direction.
Detailed parameters for EQ, modulation, and filter effects.
Controls for gain, bass, mid, treble, and output.
Controls for gain, bass, mid, treble, mode, tube, and preamp.
Settings for microphone type, center, distance, and frequency cuts.
Settings for microphone type, center, distance, and frequency cuts.
Sampling and creating custom guitar tone models.
Sampling and applying favorite stompbox or amplifier sounds.
Creating custom speaker cabinet Impulse Responses.
Settings for low, mid, high frequencies, gain, and cut-off.
Re-routing send and return paths within the signal chain.
Settings for feedback, mix, time, tempo sync, and modulation.
Settings for pre-delay, decay, low/high cut, mix, and quality.
Settings for position, min, max, and curve of the volume pedal.
Controls for on/off, frequency, gain, and cut-off for global EQ.
Calibrating expression pedals for accurate function.
Assigning parameters or on/off control to EXP pedals.
Simultaneously controlling multiple parameters with an expression pedal.
Using EXP 2 as an analog switch for external devices.
General| Amp Models | 108 |
|---|---|
| Bluetooth | No |
| IR Loader | Yes |
| Looper | 60 seconds |
| Inputs | 1 x 1/4" instrument input |
| Outputs | 1/8" headphone output |
| MIDI I/O | MIDI IN, MIDI OUT |
| USB | Yes |
| Power Supply | 9V DC |
| Expression Pedal | Built-in |
| Effects | 164 |
| Weight | 2.2 kg |
To Next Page
