AMP&STOMP
AMP&STOMP mode can be used to sample your favourite stompbox or amplifier. This can then be applied to an existing amp or Stompbox model within a preset to
transform it into your sample. stompbox effects like distortion, overdive and boost will work very well with TONE CAPTURE. However, You cannot sample stompbox
effects like delay, reverb or modulation.
Input
Output
DS/OD
STEP 1
First decide if you will capture a Stompbox or an amp.
Connect the send of GE300 to the input of your Stompbox or amp
Connect the return of GE300 to the output of your Stompbox or the send of your amp’s effects loop.
STOMPBOX
AMP
44
To Next Page
