IR
Tone capture IR mode allows you to create your own Impulse Response models of speaker cabinets to use instead of the CAB effect block. You will need a couple
of extra things to use IR mode.
1.A microphone
2.A mic preamp
3.A power amp to drive the speaker cab.
Please note that all of the above elements will be part of the tone capture and will flavour the IR. Varying each of these elements for different models
will yield different end results.
STEP 1
Connect the GE300 SEND to the power amp input (you could also
Connect the GE300 RETURN to the output of your MIC PREAMP
Mic Pream
Line out
INPUT
Mic IN
Poweramp
CAB
49
To Next Page
Loading...
