Mooer GE300 - FX Parameters

FX Parameters
Parameter
Explanation
Value
Low
Low Mid
Mid
High Mid
High
Freq
Q
Gain
Low cut
High cut
Adjusts the tone for the low frequency range.
Adjusts the tone for the low-middle frequency range.
Adjusts the tone for the Middle frequency range.
Adjusts the tone for the high-middle frequency range.
Adjusts the tone for the high frequency range.
Specifies the center of the frequency range that will be adjusted by the Gain
Adjusts the width of the area affected by the EQ centered at the Freq . Higher values will narrow the area.
Adjusts the gain for the Freq frequency range that you have assigned.
Sets the frequency at which the low cut filter begins to take effect.
Sets the frequency at which the high cut filter begins to take effect.
-12dB – 12dB
-12dB – 12dB
-12dB – 12dB
-12dB – 12dB
-12dB – 12dB
30Hz – 18000Hz
0.3 – 5.0
-16dB – 16dB
Off, 0Hz – 800Hz
Off, 20000Hz – 1000Hz
Attack(Slow Gear)
Sub(Octave)
Sub Tone(Octave)
Upper(Octave)
Upper Tone(Octave)
Dry(Octave)
Rate / Speed
Tone
Depth
Adjusts the time needed for the volume to reach its maximum. 100 is the fastest.
Adjusts the volume of the harmonic one octave below.
Adjusts the tone of the Sub frequency range.
Adjusts the volume of the harmonic one octave above.
Adjusts the tone of the Upper frequency range.
Adjusts the volume of the dry signal.
Adjusts the speed of modulation
Adjusts the tone of modulation
Adjusts the depth of modulation.
0 - 100
0 - 100
0 - 100
0 - 100
0 - 100
0 - 100
0 – 100, Bpm: 1/1, 1/2, 1/2D, 1/2T, 1/4,
1/4D, 1/4T, 1/8, 1/8D, 1/8T, 1/16, 1/16D, 1/16T.
0 - 100
0 - 100
29