Sweep
( 6 Stage Analog Phaser,
12 Stage Analog Phaser)
Moves the frequency response pattern through a six-octave or twelve-octave range.
0 - 100
Feedback
( Flanger, Modern Flanger)
Sets the level of flanger filter feedback
0 - 100
Resonance
( 6 Stage Analog Phaser,
12 Stage Analog Phaser)
0 - 100
Changes the height and sharpness of the frequency response peaks.
Level
Adjusts the level of modulation.
0 - 100
Delay
( Flanger pro, Modern Flanger)
Sets the delay time of flanger.
0 - 100
Manual
( Triple Flanger )
Controls the delay time of the flanger.
0 - 100
Width
(Triple Flanger)
Adjusts flanger LFO width.
0 - 100
Intensity
Sets the Modulation amount.
0 - 100
Output Mode
Sets up as mono or stereo
*Notes: If the modules after the FX are mono, the stereo FX you set will sound as mono effect.
Mono, Stereo
Time (Delay)
Adjusts the delay time.
0ms – 2000ms, Bpm: 1/1, 1/2,
1/2D, 1/2T, 1/4, 1/4D, 1/4T, 1/8,
1/8D, 1/8T, 1/16, 1/16D, 1/16T.
Feedback (Delay)
Adjusts the volume that is returned to the input. Higher settings will result in
more delay repeats.
0 - 100
Mix
Sets the proportion of mix between the original (dry) and 'effected' (wet) signals.
0 is total dry signal, 100 is total wet signal.
0 - 100
Pitch
Set the pitch shift value.(Detune : 100 cents = 1 semitone = 1 half-step).
-100cent – 100cent (Detune)
-12.0 – 12.0
(Mono Pitch/Poly Pitch)
Sample (Lofi)
Adjusts the sample rate of Lofi effect.
1500Hz – 44100Hz
Bit (Lofi)
Adjusts the bit rate of Lofi effect.
1bit – 16bit
Range
(Low pass filter,
High pass filter, Q filter)
Range of the position sweep
0 - 100
Drive
Adjusts the gain of effect.
0 - 100
30
To Next Page
