CHANGES SINCE V1.0.6:
• Synchronization and Timing Engine update - Analog Clock in/out and MIDI Clock all remain tightly in phase now,
eliminating the possibility of drift between these clocks which was present in earlier firmware.
• New Behavior: HOLD button acts like a Sustain Pedal (KB Hold) when Arp/Seq is not running.
• The default setting for CLOCK INPUT PPQN and CLOCK OUTPUT PPQN was changed from expecting/outputting a
clock every 8th note, to expecting/outputting a clock every 16th note (changed from 2 PPQN to 4 PPQN).
• Arp/Sequencer Gate Length can be adjusted using MIDI CC 106. Value 64 = 50% gate length (default).
• External Analog Clock overrides MIDI Sync.
• Added Arp/Seq Swing parameter (MIDI CC 14; global param ID 22).
• Added Multi-Trig parameter (MIDI CC 95).
• Arp/Seq PLAY button does not output MIDI CC 73 (can still respond to it if necessary).
• Improves compatibility with other Grandmother/Matriarchs.
• Changed MIDI Clock Output default setting to “Off”.
• Can now edit global parameters via MIDI SysEx messages (documented below).
• This also exposed a number of previously-hidden parameters which can now be edited.
NEW GLOBAL PARAMETERS & FUNCTIONS AVAILABLE FROM THE KEYBOARD
In GLOBAL EDIT mode:
1.8 Multi Trig (off,on)
2.2 MIDI OUT Filter - Panel Knobs (off, on)
2.3 MIDI OUT Filter - Pitch/Mod Wheels (off, on)
2.4 MIDI OUT Filter - Keys (off, on)
3.1 Reset Global Settings (function)
3.2 Show Firmware Version (function)
V1.1.0 RELEASE NOTES
To Next Page
Loading...
Need help?
General
