V1.2.0 RELEASE NOTES
Parameter ID Parameter Name Values
66
Arp/Seq GATE OUT Range 0 = -5V to +5V, 1 = 0V to 10V (Default: 0 / -5 to +5)
67
Round-Robin Mode 0 = Off, 1 = First-Note Reset, 2 = On (Default: First-Note Reset)
68
Restore Stolen Voices 0 = Off, 1 = On (Default: 0 / Off)
69
Update Unison on Note-Off 0 = Off, 1 = On (Default: 0 / Off)
70
Mod Oscillator Square Wave
Polarity
0 = Unipolar, 1 = Bipolar (Default: 1 / Bipolar)
71
Noise Filter Cutoff 0-16383 = dark to bright (Default: 16383)
72
Arp/Seq Random Repeats
0 = no repeating notes/steps in RND direction, 1 = allow repeating
notes (true random). Default: 1 / Allow Repeats
73
ARP/SEQ CV OUT Mirrors
KB CV
0 = Off, 1 = On (Default: 0 / Off)
Parameter Name CC Number Values
Mod Wheel
1 0 to 127 = Min to Max
Modulation Rate
3 0 to 127 = Min to Max
Glide Time
5 0 to 127 = Min to Max
Arp/Seq Rate
8 0 to 127 = Min to Max
Noise Filter Cutoff
9 0 to 127 = Min to Max
Delay Time
12 0 to 127 = Min to Max
Delay Spacing
13 0 to 127 = Min to Max
Arp/Seq Swing
14 0 to 127 = 0% to 100% (64 = no swing)
Arp/Seq Gate Length
15 0 to 127 = 0% to 100% of step duration
Oscillator 2 Frequency
16 0 to 127 = -7 to +7 Semitones (64 = no detune)
Oscillator 3 Frequency
17 0 to 127 = -7 to +7 Semitones (64 = no detune)
Oscillator 4 Frequency
18 0 to 127 = -7 to +7 Semitones (64 = no detune)
Global parameters for sysex editing (cont’d):
Matriarch MIDI CC list
Matriarch responds to the following MIDI CC messages.
Note: All CC Numbers in the range 1-31 can be used at 14-bit resolution (value range 0-16383) by using the CC number
shown below in combination with its 14-bit LSB CC, which is the CC number + 32. Example: 14-bit Oscillator 2 Frequency
uses CC 16 (MSB) and CC 48 (LSB).
To Next Page
Loading...
