Outputs | 14
ONE+TWO (R5, C3)
Mixed output of ONE input scaled by ONE
LVL and TWO input at full strength. Use
to add two signals and create interesting,
compound audio or modulation signals.
LFO (R6, C1)
LFO signal, oscillating from –5 volts to +5
volts (10V peak to peak), at a frequency
and shape determined by LFO RATE, LFO
WAVE, and any modulation. The LFO is
internally routed to many parts of Mavis,
but you can also use it as an S+H input,
patch it to the VCA for tremolo eects, or
patch it to the GATE to continually trigger
Mavis’s EG.
EG (R7, C1)
Envelope signal triggered by GATE and with
a shape determined by the EG parameters
(Attack, Decay, Sustain, Release). Like the
LFO, it is internally routed to many parts
of Mavis, but you can also use it as an
S+H input or patch it to the LFO RATE to
increase and decrease the LFO rate over
the course of the envelope.
S+H (R7, C2)
Output of Sample + Hold circuit. With
normalled signals and VCO set to SAW
WAVE, this will output pseudorandom
voltages at the rate of the LFO. You can
use this to inject randomness anywhere in
Mavis, from the VCO (1V/OCT) to the filter
(CUTOFF), VCA, or the LFO RATE itself.
ATTN (R7, C3)
Attenuator output. Outputs signal at ATTN
input scaled by ATTENUATOR knob.
MULT 1 (R8, C2)
First output of MULT. Exact copy of signal
input to MULT input.
MULT 2 (R8, C3)
Second output of MULT. Exact copy of signal
input to MULT input.
To Next Page
Loading...
Need help?
General
