MOOG SUB 37 - CHANGE LOG
NEW IN 1.2.0
• Full compatibility with Sub 37 Editor software
• Compatibility with Sub 37 USB MIDI driver for Windows
• MOD WHEEL added to the SEQ MOD DESTINATIONS list
• Sequencer MIDI output: tied notes of the same pitch are now output as one longer MIDI note instead of multiple
overlapping notes
• INIT PRESET settings changed: lower Osc 1 Level, Osc 2 waveform matches Osc 1, LFO Sync turned off
• Fixed LFO 2 Rate MIDI CC response
• Sequence is now saved in Panel Mode
Note: Is saved when you exit Panel Mode. Exit Panel Mode before turning off power to the Sub 37 if you want to save
changes to the Panel Mode sequence
• Fixed Sustain Pedal function (MIDI CC 64 / CV Mapping: SUST PED)
NEW IN 1.1.0
• Sequencer Step Edit Mode
• Quick mapping of programmable Mod Destinations
• Sequences can now include Skipped Steps and Ratchet
• Swing for the Arpeggiator, Sequencer, & Synced LFOs.
• Sequencer Mod Destination
• Sequencer Mod Only
• CV Mapping
• Variance parameter for detuning of oscillators
• Fixed sequencer MIDI output now sends MIDI notes for both Pitch 2 & Pitch 1 when in Duo Mode.
• Fixed when LATCH is on, playing a key, changing KB OCTAVE and then playing the same key now updates the played
octave correctly.
• Fixed Amp EG Latch ON no longer affects Filter EG.
• Fixed Preset Name now updates when you INIT the preset.
• Fixed Pitch Bend Up/Down changes now take effect when Local Control is OFF.
• Refer to Sub 37 Manual for complete list of changes in v1.1.0
NEW IN 1.0.7
• Fixed parameter mismatch when Master Volume set by MIDI (CC7)
• Mod buss CTRL4 (MIDI CC 2) value now updates correctly
• Improved Relative pot mode behavior when reversing direction
• Pot min/max values now reported correctly, xes Pass-Thru pot mode
NEW IN 1.0.6
• Fixed MIDI Time Code handling (MTC is ignored).
• Fixed MIDI Output Filters – Panel, Wheels.
NEW IN 1.0.5
• Small improvement to main CPU startup routine.
NEW IN 1.0.4
• Added MIDI Clock/Start/Stop output (GLOBAL MENU 2.5: CLOCK OPTIONS)
• Panel Mode gets correct rotary switch positions
• Change in External Sync behavior: does not require MIDI Start message
• Fixed possible MIDI loop when Local Control turned off
• Fixed bug where Mod Wheel value didn’t go completely to zero via external MIDI
• Velocity is now updated when re-playing an arp note which is already latched
• Fixed stuck notes via arpeggiator MIDI output
• Improved USB MIDI reliability
• Fixed NRPN output/response for Mod 1 & 2 PGM Destinations and Sources
• Fixed bug that could cause arpeggiator to freeze
• Output Mute button did not work under some circumstances; now always works.
• GLOBAL menu now shows both main & panel rmware version numbers.
• MIDI menu: POLY MAX number display was off by one (values are 1-16, was showing 0-15)
To Next Page
Loading...
