Moog Sub 37 - Important Safety Instructions

New SUB 37 SynthSound Pack
New SUB 37 SynthSound Pack
Massive Leads
Massive Leads
Installing
Installing
SynthSound Packs
SynthSound Packs
1.
1.
Make sure your Sub 37 runs OS 1.1.13 or later.
Make sure your Sub 37 runs OS 1.1.13 or later.
2.
2.
Use your PC / Laptop to unzip the downloaded file in a new folder.
Use your PC / Laptop to unzip the downloaded file in a new folder.
3.
3.
Un-zip the downloaded files.
Un-zip the downloaded files.
4.
4.
Connect your Sub 37 via USB cable or MIDI.
Connect your Sub 37 via USB cable or MIDI.
5.
5.
Install “ SendSX.exe ” and open the program at the end of the installation
Install “ SendSX.exe ” and open the program at the end of the installation
process.
process.
6.
6.
Open the file “ Sub37_Massive.syx “
Open the file “ Sub37_Massive.syx “
7.
7.
Check if your device has been recognized by the program selecting “Midi
Check if your device has been recognized by the program selecting “Midi
Out” and “Midi In “ on the program.
Out” and “Midi In “ on the program.
8.
8.
If your device has been recognized, then you can proceed to send the .syx
If your device has been recognized, then you can proceed to send the .syx
file.
file.
9.
9.
Press “ Send ( F4 ) “.
Press “ Send ( F4 ) “.
10.
10.
Enjoy your new sounds!
Enjoy your new sounds!
4
4