1715055 28 2017-08-30
Ballast Fill / Drain:
Use the Up and Down arrow keys to highlight Ballast
Fill / Drain and press Select.
Highlight the particular ballast to be filled or drained
and press Select. Utilize the + and – keys to adjust
the fill/drain times, then press the display key under
Done.
Reset Ballast
Levels:
Use the arrow keys
to highlight Reset Ballast Levels and press Select.
Use the arrow keys to highlight All, Port, Center or
Starboard and press Select. Utilize the – (Minus) key to
move the highlighting to the left (Empty) or the + (Plus)
key to move the highlighting to the right (Full). Press the
display key under Done when finished.
To Next Page
Loading...