6
User Manual
Motor Connect
For the baby hammock and the twin baby hammock, the nylon cord is
fitted around the folded fabric, approximately 7 cm (3 inches) from the
metal ring. Fasten the s-hook around the nylon cord to tighten it.
For the cradle, the nylon cord is fitted around tone of he adjustable
cradle straps, approximately 7 cm (3 inches) from the metal ring. Fasten
the s-hook around the nylon cord to tighten it.
Make sure that the nylon motorwire is not in contact with the spring cover
during movement, as this can create unwanted oscillations and wear on
both the wire and the spring cover.
When the motor and the motorwire are installed correctly, you can switch
on the power.
Read the sections on HEIGHT and WEIGHT before using the cradle
bouncer.
Please note
The nylon string is to be fastened as
close to the center of the baby ham-
mock or cradle as possible while still
leaving distance between the motor
wire and the spring. Make sure to pre-
vent the motorwire from touching and
wearing out the fabric covering the
spring.
5
To Next Page