Moons' MSST5-S - Drive Application Modes

16
17
Rev:5.0
6/08/2010
Rev:5.0
6/08/2010
MSST5/10-S UserManual
MSST5/10-S UserManual
▪ State of outputs (click the HI/LO buttons to force an output)
▪ Motor speed
▪ Voltage at the analog input
▪ Alarms or faults
▪ Status ags (enabled, motion, jogging, etc.)
The motor can be enabled or disabled from the Status Monitor by clicking the buttons at the bot-
tom of the display.
The Help Menu allows access to the help screens via Contents, gives Contact information for
MOONS’, links the user to the Website, and gives technical information About ST Congurator.
4.1.1 Drive
Choose one of the ST drive models from the drop down list on the upper right. The MSST5-S and
MSST10-S can be used for three types of applications:
1) Applications where another device controls the drive by sending electrical signals over wires.
The signals can be digital positioning pulses (step & direction or quadrature encoder following
modes) or a velocity mode where the motor speed is selected by digital or analog signals.
2) Applications where a host PC or PLC sends high level commands over a serial port using the
Serial Command Language SCL.
3) Multiaxis applications where a control program is stored in a MisNet Hub and one or more
drives are connected to it.