Moosoo YT-E-005D - Water Injection and Drainage

making mode.
－ Press the Ice selection button to set the ice size. There are three ice types to choose
from. When selected, the corresponding icon is displayed, which defaults to medium
ice
■ Washing mode
Under the standby mode, long pressing ice-making button, for 5 seconds, L/M/S icons
start shining, the machine goes into washing mode.
- Under the washing mode, long pressing ice-making button, for 5 seconds, the washing
mode stop.
■ Ice-full reminding mode
- Under standby mode or ice-making mode, when the ice cubes covered the temperature
sensor and the sensor detected that the temperature is about 2C, the ice-full icon will be
lighted, and the machine will make the “di-di” sound for 5 seconds, and go into ice-full
reminding mode automatically.
- When the temperature sensor detected that the temperature is about 4C, the machine will
go into the mode which the machine is working before the ice-full reminding.
■ Automatic water affusion and water shortage reminding mode
Under ice-making mode, when the float switch is at the minimum lever line, or the water
box is not full of water, the water shortage icon is shining, making “di-di” sound for 5s and
go into water shortage mode.
- Under water shortage mode, short press the ice-making button, the machine will go into
ice-making mode.
■ ice-making box not been reset reminding mode
- Under the ice-making or washing mode, if the ice making box is not at the ice making or
washing place, the ice-making box not been reset icon shining, and make the “di-di” sound
for 5s. The machine automatically go into the ice-making box not been reset reminding
mode.
- 20mins later, the machine will go into ice-making mode automatically.
- Under the ice box not reset mode, short pressing the ice-making button will make the
machine into ice-making mode.
■ Clock, appointment time Settings
－ Short press the "Set" button to set real-time time, ice making time and standby
time.When the first two digits flicker, press the adjustment key to set the hour
value;When the next two Numbers flash, press the adjustment key to set the minute
value.
－ Sets the real-time time when the clock icon is displayed and the clock
number flashes。
－ When the clock on icon and timer on icon are displayed and the clock number
is flashing, set the reservation time for ice making. The default reservation
time for ice making is 8:00。
－ When the clock icon is displayed, the timer shutdown icon is displayed
and the clock number flashes, set the reserved standby time. The default standby
time is 12:00
－ The clock is set to 24 hours。
■ appointment function
－ In addition to the setting state of clock and appointment time, short press
the adjustment button to turn on or off the appointment function。
－ When the timer boot icon is displayed, turn on the ice making reservation
function。
－ When the timer shutdown icon is displayed, the standby function is
enabled。
◇ Every time I press the button, it will make a "di" sound. The LCD screen is
backlit in 60S and goes out, only ICONS and clock are displayed.
Water injection and drainage
■ Water injection
－ Water injection is required when the water volume in the storage area is
lower than the minimum water level mark or water 。
－ Artificial injection of drinking water into the storage area。