Moosoo YT-E-005D - Analysis and Exclusion of Special Phenomena; No Display or Sound Issues; Leakage Water; Ice Making Process Issues

Reduce the time of keeping the door/cover open.
■ Clear the ventilating grill at regular time.
Other attentions
Turn off, stop using
－ Take out the plug if you want to turn off the machine.
－If the machine will stop using for a long time, please work as these steps:
cleaning, turn off the machine, and leave a little gap between the door and the
machine.
ATTERNTION: IF YOU DECIDE NOT TO USE THE ICE MAKER ANY MORE, THE STORAGE COULD
NOT STOGE ANY FOOD
Non - fault phenomenon analysis and elimination
Fog condensation：
The air humidity may be too high. Please rub away the drop of water.
Obvious different size of ice cube
Stop and restart, try several times. The cooling system is not stable at first
several rounds.
The ambient temperature is too low.
Ice cube too small
Ambient temperature is too high or the water temperature is too high.
Strange noise (“si-si” “hu-hu” “di-da” “wu-wu”)
When the cooling system is working, the freezing medium flowing in the tube will
cause the noise of “si-si”;
When the cooling system is working, the wind fan will cause the noise of “hu-hu”.
When the water box arrives at the deice place, it will cause the noise of “di-da”
by turning on/off the solenoid valve.
When it is watering to the inner box, it will cause the noise of “wu-wu”.
All the above situations are normal.
Analysis and exclusion of special phenomena
phenomena
Possible cause
handling method
No DISPLAY on
LCD screen, no
prompt sound
when pressing
keys
The power plug is not
properly plugged in;
Power failure; The
control system is broken
Plug into a power outlet;
Check for power failure;
Professional personnel are
needed to check the
maintenance control system
Leakage water
The drain nut is not
tightened; The drain
plug is not plugged;
Excessive water
injection exceeds the
position of the ice box,
and the internal water
circulation pipe is not
connected properly or
damaged；
Tighten the nut; Plug the plug
and tighten the nut; Remove
excessive water, need
professional personnel to
check and maintain the
internal water circulation
line;
If there is
water in the
storage area,
please add
water
The ice-making mode is
not on; The amount of
water below the minimum
water level; The outlet
of water storage area is
blocked; Pure or
distilled water is
injected; Fault of
internal water
circulation and its
detection system
Turn on ice making mode; Add
water according to the water
injection instructions;
Remove foreign matter from
outlet of water storage area;
Add a little salt to purified
water or distilled water;
Professionals are needed to
inspect and maintain the
internal water circulation
and its detection system;
Ice storage
area free of ice
or small amount
of ice,
indicating full
The ambient temperature
of the place is lower
than 3 ℃ ; Ice on the
temperature sensor; The
temperature sensor
Place in a suitable
environment; Remove ice
shelved or automatically
recover after ice melts
naturally; Professionals are
！