－ Each water injection shall keep the water volume between the maximum and
minimum water level marks and shall not exceed the maximum water level marks。
◇ Warning: Only potable water can be filled。
■ drainage
－ When the water in the storage area is polluted or the inner wall of the
storage area needs to be cleaned, drainage shall be carried out。
－ Remove the power plug before draining the water。
－ Move the ice maker so that the water outlet is in a position suitable for
manual operation and drainage
－ Unscrew the drain nut and remove the plug, the water will flow out
automatically。
－ After draining, plug the plug immediately and tighten the drain nut。
◇ When injecting water or draining water, ensure that no water is injected or
splashed onto the live parts of the appliance to avoid danger
◇ When used again after draining, check whether there is leakage at the drain
outlet to ensure that there is no leakage to continue to use.。
Reminder
■ When the ice - making mode is on, avoid reaching into the ice - making area
to prevent danger。
■ When using purified water or distilled water to make ice, there may be a false
alarm of lack of water, as long as a little salt can be added
■ The design of the ice box is not reset reminder mode is a protective function.
In general：
－ When there is ice or foreign body around the outside of the ice box to block
the rotation of the ice box, it is only necessary to manually remove the ice
or foreign body。
－ When the ice on the icicle greatly affects the rotation of the water box,
it is necessary to wait for the ice to melt naturally before using. It is not
allowed to forcibly remove the ice on the icicle。
■To avoid contamination of food, please follow the following instructions：
－ Opening the door (cover) for a long time can cause a significant increase
in the temperature of the ice maker storage room。
－ Regularly clean surfaces that may come in contact with food and accessible
drainage systems;Clean the water tank if it has not been used for 48 hours;If
water is in the tank for more than 5 days, flush the water circulation system
connected to the water supply system。
－ If the ice maker is empty for a long period of time, close, defrost, clean,
dry, and keep the door (cover) open to prevent mold from forming inside the ice
maker。
cleaning
■ Precautions for storage room and external cleaning：
－ You must unplug the plug before cleaning。
－When cleaning, ensure that water does not enter the live area。
－ Use a soft towel dipped in warm water or a neutral cleaner to scrub the inside
and outside surfaces of the ice maker。
－ Do not scrub with a cleaner that contains an abrasive (such as toothpaste),
an acid, a chemical solvent (such as alcohol), or a polish。
－ Do not rinse with water。
Inner cleaning
Refer to the “Affusion”, add the water mixed with 50% vinegar.
Open the swill mode.
After the will mode end, drain the water referring to the “Drainage”
Circling with adding the water, and draining the water along with washing, until
the draining water is clear.
Maintains
The ice maker should be put at the place where is dry and ventilative, to prevent
the machine from the heat source and sunshine.
The over-temperature water should be cooled down to indoor temperature for
ice-making.
To Next Page
Loading...