14
1. Use the following checklist to ensure all features function as indicated.
System Testing
Service Mode
Service mode is used whenever it is necessary to disable the remote start
feature, such as during vehicle service. The vehicle will not start by remote if
Service mode is activated.
1. Entering Service mode.
A. Turn ignition on with the key.
B. Press the start button on the remote transmitter 3 times. 2 seconds later,
the horn will chirp and the lights will flash 3 times, indicating the system
is in Service mode.
C. While in Service mode, whenever a remote start attempt is made, the
horn will chirp and the lights will flash 3 times alerting the user that the
system is in Service mode.
2. Exiting Service mode.
A. Turn ignition on with the key.
B. Press the start button on the remote transmitter 3 times. 2 seconds later,
the horn will chirp and the lights will flash 1 time, indicating the system
has exited Service mode.
R emote s ta rt - P res s s ta rt button 2X .
Remote stop - Press and hold start button for 2 seconds.
Hood safety switch shutdown - While under remote start, open hood - engine should shut down.
Brake safety shutdown - While under remote start, press brake - engine should shut down.
K ey-in-s e ns e circuit - W ith key in the ignition cylinder, remote s ta rt s hould not a ctiva te.
Overrev shutdown - While under remote start, press accelerator - system should shut down at 3X idle.
S ervice Mode - W ith ignition turned on with key, pres s re mote s ta rt button 3X . R epea t to exit S ervice Mode.
Heater/Air C onditioning - E nsure Heater/AC works during remote start.
To Next Page
Loading...