To Next PageTo Next Page
Need help?Do you have a question about the Mopar Remote Start System and is the answer not in the manual?
General| Brand | Mopar |
|---|---|
| Model | Remote Start System |
| Category | Remote Starter |
| Language | English |
Steps to remove lower dash panels under the steering column.
Steps to remove the dash panel on the left side.
Steps to remove the driver's kick panel cover.
Instructions for placing fuses into the control module.
Instructions for installing the DNA into the control module.
Steps to install the hood safety switch.
Instructions for mounting and routing the dipole antenna.
Connect custom harness to vehicle's ignition switch connector.
Secure harness with wire tie and ground wire with screw.
Connect White/Tan wire to the brake switch connector.
Splice harness wire into multifunction switch connector.
Splice harness wire into white 6-way connector.
Route wires through cowl and connect to hood safety switch.
Splice Red/Yellow wire to coil connection for gas engines.
Splice Red/Yellow wire to ECM connector for diesel engines.
Apply primer and tape to SKIM/SKREEM antenna coil.
Route antenna loop to ignition cylinder and secure.
Connect 24-way, 10-way module connectors and antenna.
Steps to program remote transmitters to the system.
How to change installer programmable options for the system.
Procedure to access and program Option Bank 2.
How to reset system options back to their default settings.
Procedure to set a 30-second crank delay for diesel engines.
Steps to program the tachometer rate for system operation.
Information about ensuring a valid tach signal.
Tach rate programming must be done before SKIM/SKREEM learn.
Steps to enter Customer Learn programming mode.
Instructions to program the SKIM/SKREEM Interface module.
Vehicle may stall on first remote start attempt during learn.
Test remote start and stop functions.
Test hood safety and brake safety shutdown features.
Test key-in-sense, overrev, service mode, HVAC.
Procedure to enable Service Mode for vehicle service.
Procedure to disable Service Mode.
Securely mount modules and harnesses under the dash.
Reverse the dash disassembly procedure.
Details of options available in Option Bank 1.
Details of options available in Option Bank 2.
Diagnose and fix issues when horn honks 4 times and no tach is learned.
Troubleshoot starter cranking for too long.
Address ignition activation with horn honks and no start.
Troubleshoot horn honks and no start due to safety input.
Resolve horn honks and no start when Service Mode is engaged.
Fix vehicle starting then stalling due to SKIM/SKREEM issues.
Troubleshoot horn honks and no start due to safety feature limits.
Steps to open the remote transmitter.
Instructions for replacing the battery in the remote control.
Wiring details for steering column connectors.
Wiring for ignition switch and brake switch.
Connections for hood tilt switch and ground.
Wiring to ignition coil or ECM for engine connections.
Connections for the PC-12 module and antenna.
