Morgana Documaster MK3 - Creaser Operation Programming and Settings

Page 17
SYSTEM
Setting the Machine up as a Creaser
1 Creases
Program 1
Total 20
Reset
Setup
Tools
Feed
Batch Off
Autocreaser
Operate This Machine
No
Yes
Are You Trained To
2. If the text on the display contains the word the machine is in the
Booklet Maker mode of operation.
To change to the Creaser mode of operation proceed as follows:-
(i) Move the selection switch up to select .
(ii) Move the selection switch down to .
(iii) Move the selection switch to the right to select .
3. The length of suction on the sheet of paper being fed can be adjusted by setting the
feed type as follows:-
(i) Move the selection switch to the right to select .
(ii) Move the selection switch down to select the required feed type ( ,
, , or )
(iii) Move the selection switch to the right to select .
‘Book’
Set Feed
Reset
Mode to Autocreaser
Mode to Autocreaser
Setup
Long Pulse
Medium Pulse Short Pulse Stream Feed
Select
A typical Autocreaser display menu is shown below.
IMPORTANT.
Programming the machine for Creaser operation
1. Switch the power ‘on’ by turning the Emergency stop button clockwise to release the
safety latch. The display is now switched on and will be as shown below.
If you have not been trained to operate this machine, we strongly advise that you move the
selection switch to the right to select . We recommend that you either seek training or
ask a trained operator to run the machine for you.
Move the selection switch to the left to select only if you have been trained to operate
this machine. If you have not been trained to operate this machine and you select ,
Morgana Systems Ltd accept no responsibility for personal injury, damage to the
machine or damage to materials being processed by the machine.
No
Yes
Yes
MORGANA
DocuMaster MK3