Page 35
SYSTEM
Recognition On
Recognition
Home
More
Back
Tens Decimals
Position: 90.0
Capture Image
Recognition
Location: (Cover) -
Back
Position: 90.0
Recognition
Location: (Cover) -
(iii) Move the selection switch down, (selecting ). If the display
reads , move the selection switch to the right to change
it to .
(iv) Move the selection switch down.
(vi) Move the selection switch down.
Recognition
Recognition Off
Recognition On
(v) The that contains the image to be captured can now be set by
rotating the Selection Switch, (clockwise to increase or anti-clockwise to
decrease).
(vii) The of the image to be captured (from the leading edge of the
sheet) can now be set as follows:-
Move the Selection Switch to the left to select or to the right to
select . The or (whichever has been selected)
can then be adjusted by rotating the Selection Switch, (clockwise to
increase or anti-clockwise to decrease).
The default position, (of the image capture position), from the leading edge of
the sheet is 90mm.
Page
Position
Tens
Decimals Tens Decimals
NOTE:-
Limitations of the position of the Image, to be captured, on the sheet.
DocuMaster MK3
To Next Page
Loading...
