REGULAR INSPECTION B-19
12. TIMING BELT REPLACEMENT
Some gravity axes are driven by a timing belt turned by a motor shaft. If the machine employs a
timing belt to drive the gravity axis, replace the timing belt periodically.
Contact the Mori Seiki Service Department for assistance when replacing timing belts.
<Replacement Interval>
Once every 5 years
Stop machine operation immediately and contact the Mori Seiki Service Department for
assistance in the event of any abnormality, even if replacement is not due yet.
WARNING
If the same timing belt is used without replacement, the axis could drop
due to damage and wear of the belt, causing damage to the machine.
NOTE
CAUTION
To Next Page
Loading...
Need help?
General
